Sunleaves Pioneer Lighting Systems - 4 Foot

Purchase Sunleaves Pioneer Lighting Systems - 4 Foot

A portion of the proceeds from the sale of these units benefits the Hydro for Hunger initiative that battles hunger around the world.

Sunleaves Pioneer IV, VI, VIII
Instructions
Thank you for choosing to grow with Sunleaves products!
Your satisfaction and success are important to us. For best
results, carefully read the following instructions before using
your Sunleaves Pioneer IV, VI, or VIII fluorescent light system.
About your Sunleaves Pioneer Fixture

•  Delivers high yields with low wattage (IV=216W, VI=324W, VIII=432W)
•  Exclusive wide dispersion reflector design ensures maximum coverage
•  Hangs vertically or horizontally
•  For use with T5 fluorescent tubes; VitaLUME T5s recommended
•  “Grow” and “bloom” tubes are interchangeable and may be used in the same fixture simultaneously
•  Built-in 120-volt outlet to link multiple systems:

Pioneer IV =max 7 linked fixtures
Pioneer VI =max 5 linked fixtures
Pioneer VIII =max 3 linked fixtures

Using the Pioneer Fixture
1. Remove all packing materials.
2. Install tubes if not already installed (see below).
3. Attach provided hanging wires to hooks. Be sure hooks are secure.
    Reflector should hang level (see below for vertical hanging instructions).
4. Plug into 120-volt outlet or timer to turn on light.
Note: DO NOT use fixture as a shelf, the hanging hardware is designed to support the weight of the fixture only.

Installing or Replacing Tubes in your Pioneer Fixture
When it’s time to replace an old tube or install a new tube—or if you’d simply like to encourage a different stage of
plant growth, simply follow these steps to replace Pioneer tube(s):
1. Make sure fixture is powered off and unplugged.
2. To remove old tube: grasp tube at both ends, make a 1/4 turn and carefully     slide tube retainer pins from fixture slot.
3. To insert new tube: guide tube retainer pins into fixture slot. Make sure both     ends are fully seated and turn tube 1/4 turn.

For Vertical Positioning:
1. Remove hanging wires from their initial installation points by carefully                 unscrewing the hanger nut (the hanging
    wire stays in the nut).
2. Remove the caps from the end opposite the power cord.
3. Carefully screw hanging nuts into these holes.
4. Attach hanging wire to a secure hook.

Pioneer Fixture Maintenance
For maximum reflectivity, be sure to keep the interior of your Pioneer reflector free of dust and fingerprints. The

Pioneer fixture’s reflective surfaces can be gently cleaned with a soft, damp cloth. Before cleaning, make sure light
system is unplugged and cool to the touch.

Purchase Sunleaves Pioneer Lighting Systems - 4 Foot